Any machine as powerful & sharp as the ACME must have
maximum built-in safety. The safety system adopted by us
eliminates accident risk.
       

PHOTO ELECTRIC SAFETY GUARD:

The photo electric circuits incorporates a self  test, with use of neon bulb placed above each photocell. If anything obstructs the light beams, the knife stops immediately. The positive drive of the machine ensures that when the knife is moving up after cutting the stock  it stops only at its desired  position.

PREVENTING FROM MISHANDLING.

The machine is provided with a key switch, removal of key from the stops the machine. Also a positive brake system ensures that the knife stops instantaneously if in motion, incase the power supply fails.

MECHANICAL OVER LOAD PREVENTION:

The machine is provided with shear bolts that guards against over loads, they provides full protection on each cut.

EXAMINE OUR STRONG POINTS

• The cast iron frame has been reinforced for extra strength. It's sturdy design eliminates all risks of vibration & excessive strain.

• The smooth cutting cycle is fast & accurate, even when you're cutting hard material or high stack. Moreover, the knife drive & clamp are dimensioned for heavy duty. Since the drive mechanism runs in an oil bath, lubrication is limited to a single oil change per year, thus reducing maintenance cost.

• The fast cutting stroke is very accurate, to the knife carrier guides. All sliding surfaces have been precisely ground, guarantee of dependable precision & long service life.

• High pressure ..... Hydraulics are used for precise, automatic clamping. The clamp starts gently & sets dawn softly on the stock. After contact has been established, the clamping pressure is increased automatically to the preset value, avoiding any distortion of the stock.

• .... And low pressure, when the clamp is used to help align the stack, it is operated by a foot pedal & clamping pressure adjusted to 40 Kg. approximately to protect the operator.

• The machine is provided with optical cutting line indicator, making the job more easier for operator to set the setting marks.

• The back gauge which moves smoothly is guided precisely on a coloumn & side plates up to the length of knife carrier ensures a right angle cut even at the smaller length of the stock. The hand wheel mechanism provides comfort to the operator for the fine adjustments of the cutting marks.

• Simple & safe knife change, knife guides provided with the machine, helps removing of the knife easily avoiding any danger to the operator & provision of positive braking system forces operator to switch off the mains supply while process is carried out, avoiding any chances of accidents.

WE ARE PLANNING TODAY...
                                            FOR YOUR NEEDS TOMORROW.